Refurbish Your Wheels At Home And Save Money

Over time and harsh road conditions, your car’s wheels may start to get depleted. Also, the constant usage without a proper service may lead them to provide a gloomy appeal. You may have never noticed this but a majority of motorist prefer wheels that complement the look of your vehicle. No one likes to ride a boring vehicle that doesn’t give you the correct vibe.

It is very clear that the wheel refining process can cost you heavily. How would you feel if you were told that wheels can be refurbished at home as well? You read that right, it is possible. All you need to do is know the correct technique.

Keep the following things at hand

Primer

Wet and Dry Sandpaper

Masking tape

Filler

Paint

Lacquer

Step 1: Clean them well

After you have removed the wheel from the vehicle, cleansing should be done. Though you can carry on without detaching the wheels, it may cause inconvenience. You need to make sure that the wheel has been properly cleaned. Not an inch should be left as it may lead the paint to have a rough base. Also, get rid of all the dust particles before you start with the next step.

Step 2: Mask the tyres

If your car’s wheels are fitted with tyres, you will have to cover them. The best option will be using masking tape. This will protect the tyres from unwanted spots and damages.

Step 3: Sandpaper and levelling

This step involves sanding the BROCK Alloy Wheels surface with the help of sandpaper. Start with coarse and high grit sandpaper to clean the entire wheel surface. You may also have to go down to the bare metal in case you notice corrosion or paint flake.

Step 4: Using a filler

The defects and damages that will be left after the sanding stage can be filled using a filler. This will help in filling the damage marks and various other defects.

Step 5: Primer

There is a high possibility that after filling the wheel damages, some residues may have been left on the surface. It is best to clean or wash it before moving further. After washing the surface, you will need a primer. Shake the primer well and then apply 4-5 layers of primer on the wheel. A primer takes almost 48 hours to dry.

Step 6: Paint

Here you are with the most interesting part. Painting the wheel is not a difficult task. Buy the wheel paint of your choice and get done with this task happily. You can paint the wheels using a rattle can or powdered paint.

During the painting stage, make sure that you are holding the paint spray a little away from the Alloy Wheels. This helps in giving a smooth and professional look to the wheels. Now you can apply thin coats of paint. 4-5 layers would be adequate, the rest will depend on your choice.

Step 7: Coating

After the paint has dried, which usually takes 48 hours. You can spray the lacquer onto the wheel. It will act as a protective layer. This will help in prolonging the life of the paint. The coating will also take a few hours to dry, then you can re-install the wheel back to the vehicle.

The wheel refurbishment process is not as difficult as it sounds. You simply need certain tools and equipment, and a little patience. This will save you a lot of money and your wheels will look brand new.

Leave a Reply

Your email address will not be published. Required fields are marked *